The AD7680 is a 16-bit, fast, low power, successive-approximation ADC. The part operates from a single 2.5 V to 5.25 V power supply and features throughput rates up to 100 kSPS. The part contains a low-noise, wide bandwidth track/hold amplifier, which can handle input frequencies in excess of 100 kHz.

The conversion process and data acquisition are controlled using CS and the serial clock, allowing the devices to interface with microprocessors or DSPs. The input signal is sampled on the falling edge of CS and the conversion is also initiated at this point. There are no pipelined delays associated with the part.

The AD7860 uses advanced design techniques to achieve very low-power dissipation at fast throughput rates. The reference for the part is taken internally from VDD. This allows the widest dynamic input range to the ADC. Thus the analog input range for the part is 0 to VDD. The conversion rate is determined by the SCLK frequency.

• AD5342 - +2.5V至5.5V、230 μA、双通道、轨到轨电压输出12位DAC，内置并行接口，采用28引脚TSSOP封装
• ADG3248 - 2.5 V/3.3 V、2:1多路复用器/解复用器总线开关
• HMC3587 - HBT增益模块MMIC放大器，4 - 10 GHz
• AD5444 - 12-Bit、高带宽、串行接口乘法DAC、内置一条串行数据输出线
• AD8366 - dC至600 MHz 、双通道数字可变增益放大器
• ADM1085 - 内置高电平有效、开漏使能输出的电压时序控制器
• HMC-C022 - 宽带低噪声放大器模块，2 - 20 GHz
• AD684 - 单芯片四通道采样保持放大器(SHA)
• ADP1708 - 1 A、低压差、CMOS线性稳压器
• ADUM142E - 带输出使能和2个反向通道的鲁棒、四通道隔离器